This module provides DCC SEND/GET support and userfile transfer support for userfile sharing.
- Config file settings
1. Config file settings
Put this line into your Eggdrop configuration file to load the transfer module:
There are also some variables you can set in your config file:
- set max-dloads 3
Set here the maximum number of simultaneous downloads to allow for each user.
- set dcc-block 0
Set here the block size for dcc transfers. ircII uses 512 bytes, but admits that may be too small. 1024 is standard these days. Set this to 0 to use turbo-dcc (recommended).
- set copy-to-tmp 1
Enable this setting if you want to copy files into the /tmp directory before sending them. This is useful on most systems for file stability, but if your directories are NFS mounted, it's a pain, and you'll want to set this to 0. If you are low on disk space, you may also want to set this to 0.
- set xfer-timeout 30
Set here the time (in seconds) to wait before an inactive transfer times out.
Copyright © 1997 Robey Pointer
Copyright © 1999 - 2010 Eggheads Development Team Eggheads Development Team